Clarity Visual Systems
8.Detach the lamp Using your thumb and middle finger to unlock the lamp cable
cable | connector, use your index finger to pull the connector away from |
| the lamp. |
| The lamp cable will remain connected to the optical engine. |
9.Remove the lamp Push the lamp to the right (into the optical engine) while turning counterclockwise. The lamp will rotate about an eighth of a turn, and then it can be pulled to the left (out) and removed.
10.Install the new lamp and reassemble the display
11.Reinstall
Reinsert a UHP 100W lamp in the same orientation. Push the lamp in and rotate the lamp clockwise until it locks into place.
When attaching the lamp cable, pinch the connector clamp together while inserting the connector. The connector is keyed so it will only go on one way.
Replace the lamp access door on the optical engine. Close and latch the projector compartment hood.
Reinstall the screen by lining up the latches and pressing the screen inward. It will go in with a distinct “pop.” Give it a slight pull to see that it is securely in place.
Removing a Standard Screen Using the Screen Removal Tool
1.Find the bumps on On both sides of the screen, near the top and bottom, the
the side mullions | mullion is slightly lifted from the screen material, forming a |
| little bump. The removal tool fits here. |
2.Insert the removal The small hook on the removal tool slips under the bump in
tool | the mullion. The other side of the tool should press against the |
| mullion of the neighboring screen. Use care when using the |
| tool so it doesn’t scratch the screen material. |
3.Squeeze the handle Squeezing the handle of the removal tool pulls one screen out
of the | far enough to let it “pop” out at that corner. The tool uses the |
| neighboring screen for leverage. |
4.Repeat for all four Remove the screen carefully and set it aside. corners
68September 1999
