Clarity WN=5230-S manual Troubleshooting, Power and Start-Up Problems

Clarity Visual Systems

Troubleshooting

This section provides tips and strategies for resolving problems or issues you may encounter, either during installation or in normal use of the WN-5230-S. Many problems can be rectified without the need for service by following the troubleshooting steps below.

If you are unable to resolve the problem by following the suggestions listed under the Failure Symptoms column, you will need to contact your service provider.

Power and Start-Up Problems

When AC power is applied to the unit by turning on the main AC power switch, the display enters a 30 second standby-delay period to prevent ignition of a hot lamp. During this time, the display will not accept commands from the remote control.

The unit enters the Standby mode when the 30 second standby-delay sequence is complete. The display is ready to accept an “ON” command when the Standby LED comes on.

This is the sequence of events that must occur for a WN-5230-S to power-up and display an image.

72September 1999