The following fields can be set:
ParameterDescription
Interface name:
[ ] TX Mode <Disabled>
RX Mode <Disabled>
Authentication:
Disabled
Password:
The name of the IP interface on which RIP is to be setup. This interface must be previously configured on the switch.
Toggle among Disabled, V1 Only, V1 Compatible, and V2 Only. This entry specifies which version of the RIP protocol will be used to transmit RIP packets. Disabled prevents the transmission of RIP packets.
Toggle among Disabled, V1 Only, V2 Only, and V1 and V2. This entry specifies which version of the RIP protocol will be used to interpret received RIP packets. Disabled prevents the reception of RIP packets.
Toggle between Enabled and Disabled. When authentication is enabled, a password is used to authenticate communication between routers on the network. Authentication is only supported when RIP is in V1 Compatible or V2 only mode.
A password to be used to authenticate communication between routers on the network.
Setup Open Shortest Path First (OSPF)
MD5 Key Table Configuration
To access the MD5 Key Table Configuration screen, highlight MD5 Key Table Configuration on the menu above, and press Enter.
