DES-3326 Layer 3 Fast Ethernet Switch User’s Guide

Figure 7-29. Setup RIP window

To edit a RIP configuration, click the Hand icon.

Figure 7-30. Setup RIP – Edit window

The following fields can be set:

Parameter Description

Subnet Name The name of the IP interface on which RIP is to be setup. This interface must be previously configured on the Switch.

TX Mode <Disabled>

Toggle among Disabled, V1 Only, V1 Compatible, and V2 Only. This entry specifies which version of the RIP protocol will be used to transmit RIP packets. Disabled prevents the transmission of RIP packets.

RX Mode <Disabled>

Toggle among Disabled, V1 Only, V2 Only, and V1 and V2. This entry specifies which version of the RIP protocol will be used to interpret received RIP packets. Disabled prevents the reception of RIP packets.

PasswordA password to be used to

authenticate communication between routers on the network.

Authentication Toggle between Disabled and Enabled to specify that routers on the network should us the Password above to authenticate router table exchanges.

216

Page 216
Image 216
D-Link DES-3326 manual Setup RIP window, 216