Figure 7-51. Setup Static Unicast MAC Forwarding window
The following fields can be set:
| Parameter | Description | |
| MAC Address | Allows the entry of the MAC address | |
|
| of an end station that will be entered | |
|
| into the switch’s static forwarding | |
|
| table. | |
| VID | Allows the entry of the VLAN ID (VID) | |
|
| of the VLAN the MAC address below | |
|
| is a member of. | |
| Port | Allows the entry of the port number | |
|
| on which the MAC address entered | |
|
| above resides. | |
|
|
|
|
IP Forwarding
With the switch in Layer 3 Operation mode, entries into the switch’s forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding is accomplished by the entry of an IP address into the Static IP Routing table.
Static Address Resolution Protocol (ARP) entrees can also be made from the Forwarding menu.
Click the Static/Default Routes link on the IP Forwarding menu (under Configuration → Forwarding):
Figure 7-52. Static/Default Routes window
To delete an existing static/default route, click the X icon under the Delete column corresponding to the entry you want to delete.
To add a new static/default route, click the New icon:
