D-Link DES-3326 Area ID, Router Priority, Hello Interval, Dead Interval, Auth. Type None, Metric

DES-3326 Layer 3 Fast Ethernet Switch User’s Guide

The following fields can be set:

ParameterDescription

Interface		Allows the entry of the name of an IP interface previously
Name:[System	]	configured on the switch.
Area ID:[0.0.0.0]		Allows the entry of an OSPF Area ID configured above.
Router Priority:[1]		Allows the entry of a number between 0 and 255
		representing the OSPF priority of the selected area. If a
		Router Priority of 0 is selected, the switch cannot be elected
		as the Designated Router for the network.
Hello Interval:[10 ]		Allows the specification of the interval between the
		transmission of OSPF Hello packets, in seconds. Between 5
		and 65535 seconds can be specified. The Hello Interval, Dead
		Interval, Authorization Type, and Authorization Key should
		be the same for all routers on the same network.
Dead Interval:[40 ]		Allows the specification of the length of time between the
		receipt of Hello packets from a neighbor router before the
		selected area declares that router down. An interval between
		5 and 65535 seconds can be specified. The Dead Interval
		must be evenly divisible by the Hello Interval.
State:<Disabled>		Allows the OSPF interface to be disabled for the selected area
		without changing the configuration for that area.
Auth. Type:<None>		This field can be toggled between None, Simple, and MD5
		using the space bar. This allows a choice of authorization
		schemes for OSPF packets that may be exchanged over the
		OSPF routing domain. None specifies no authorization.
		Simple uses a simple password to determine if the packets
		are from an authorized OSPF router. When Simple is
		selected, the Auth Key field allows the entry of a 8 character
		password that must be the same as a password configured
		on a neighbor OSPF router. MD5 uses a cryptographic key
		entered in the MD5 Key Table Configuration menu. When
		MD5 is selected, the Auth Key ID field allows the
		specification of the Key ID as defined in the MD5
		configuration above. This must be the same MD5 Key as
		used by the neighboring router.
Auth. Key:[ ]		MD5 uses a cryptographic key entered in the MD5 Key
		Table Configuration screen. When MD5 is selected, the
		Auth. Key ID field allows the specification of the Key ID as
		defined in the MD5 configuration above. This must be the
		same MD5 Key as used by the neighboring router.
Metric:[1	]	This field allows the entry of a number between 1 and 65,535
		that is representative of the OSPF cost of reaching the
		selected OSPF interface. The default metric is 1.

129