Dell R410 Removing the Integrated Storage Controller Card

100 Installing System Components
Removing the Integrated Storage Controller Card
WARNING: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
3 If installed, remove the expansion card. See "Removing an Expansion
Card" on page99.
4 Remove the card from the storage controller card slot:
a Pull the blue release lever to free the card from the connector on the
expansion-card riser.
b Lift to remove the card.
Figure 3-12. Installing the Integrated Storage Controller Card
1 SAS data cable connector 2 storage connector
3 expansion card riser 4 integrated storage controller card
5 release lever (blue)
2
134
5
book.book Page 100 Tuesday, March 31, 2009 5:26 PM