
3Open the system. See "Opening the System" on page 82.
4Disconnect the power and data cables from the back of the drive.
Note the routing of the power and data cables underneath the tabs on the system chassis as you remove them from the system board and drive. You must route these cables properly when you replace them to prevent them from being pinched or crimped.
5To remove the drive, pull the release latch and lift and angle the drive to release it from the notch on the metal standoffs. Lift the drive out of the chassis. See Figure
6Close the system. See "Closing the System" on page 83.
7If applicable, replace the optional front bezel. See "Removing and Replacing the Optional Front Bezel" on page 81.