Changing the FortiGate firmware

System status

 

 

6Enter the following command to restart the FortiGate unit: execute reboot

As the FortiGate units starts, a series of system startup messages is displayed. When one of the following messages appears:

Press any key to enter configuration menu.....

......

7Immediately press any key to interrupt the system startup.

Note: You have only 3 seconds to press any key. If you do not press a key soon enough, the

FortiGate unit reboots and you must log in and repeat the execute reboot command.

If you successfully interrupt the startup process, one of the following messages appears:

[G]: Get firmware image from TFTP server.

[F]: Format boot device.

[B]: Boot with backup firmware and set as default.

[Q]: Quit menu and continue to boot with default firmware.

[H]: Display this list of options.

Enter G,F,B,Q,or H:

8Type G to get the new firmware image from the TFTP server.

9Type the address of the TFTP server and press Enter. The following message appears:

Enter Local Address [192.168.1.188]:

10Type the address of the internal interface of the FortiGate unit and press Enter.

Note: The local IP address is used only to download the firmware image. After the firmware is installed, the address of this interface is changed back to the default IP address for this interface.

The following message appears:

Enter File Name [image.out]:

11Enter the firmware image filename and press Enter.

The TFTP server uploads the firmware image file to the FortiGate unit and messages similar to the following are displayed:

Save as Default firmware/Run image without saving:[D/R] Save as Default firmware/Backup firmware/Run image without saving:[D/B/R]

12Type D.

The FortiGate unit installs the new firmware image and restarts. The installation might take a few minutes to complete.

60

Fortinet Inc.

Page 60
Image 60
Fortinet 50A user manual Press any key to enter configuration menu