Configuring PPTP | PPTP and L2TP VPN |
|
|
2Add and configure PPTP users.
For information about adding and configuring users, see “Adding user names and configuring authentication” on page 172.
3Go to User > User Group.
4Add and configure PPTP user groups.
For information about adding and configuring user groups, see “Configuring user groups” on page 177.
To enable PPTP and specify an address range
1Go to VPN > PPTP > PPTP Range.
2Select Enable PPTP.
3Enter the Starting IP and the Ending IP for the PPTP address range.
4Select the User Group that you added in “To add users and user groups” on page 203.
5Select Apply to enable PPTP through the FortiGate unit.
Figure 29: Example PPTP Range configuration
To add a source address
Add a source address for every address in the PPTP address range.
1Go to Firewall > Address.
2Select the interface to which PPTP clients connect.
3Select New to add an address.
4Enter the Address Name, IP Address, and NetMask for an address in the PPTP address range.
5Select OK to save the source address.
6Repeat for all addresses in the PPTP address range.
204 | Fortinet Inc. |
