6

The Development Library

Introduction

Built into the calculator is a set of functions not accessible to the user by default. These functions are in a library that contains low level development tools mainly designed for use in developing System RPL and assembly programs.

In order to enable this library, you must attach it with the command 256 ATTACH or by setting flag –86. When the library is attached after the next warmstart (or reset), it appears in the APPS menu. You may reset the calculator by

pressing $and Cat the same time.

Note: The tools and programs in this library are extremely powerful, and misusing them will cause memory loss.

Back up your calculator before trying these commands.

Equation Reference 6-1