The $RESET$ operation („&ÔL %RESET% ) resets the PPAR parameters (except ptype) to their default values,
and erases PICT. (Note: the & means to press and hold the „key while pressing Ô).
Note that res behaves differently for the statistical plot types BAR, HISTOGRAM, and SCATTER than for other plot types. For BAR, res specifies bar width; for HISTOGRAM, res specifies bin width; res does not affect
SCATTER.
PRTPAR
PRTPAR is a variable in the HOME directory that contains a list of printing parameters. It is created automatically the first time you use a printing command.
|
| Default |
Parameter (Command) | Description | Value |
|
|
|
delay time (DELAY) | A real number, in the range 0 to 6.9, specifying the | 0 |
| number of seconds the calculator waits between |
|
| sending lines. This should be at least as long as the |
|
| time required to print the longest line. If the delay is |
|
| too short for the printer, you will lose data. The delay |
|
| setting also affects serial printing if |
|
| (in IOPAR) is not being used. |
|
remap (OLDPRT stores the | A string defining the current remapping of the | Empty |
extended character set for printing. The string can | string. | |
for the HP 82240A Infrared | contain as many characters as you want to remap, with |
|
Printer) | the first character being the new character 128, the |
|
| second being the new character 129, etc. (Any |
|
| character number that exceeds the string length will |
|
| not be remapped.) See the example below. |
|
line length | A real number specifying the number of characters in | 80 |
| a line for serial printing. This does not affect infrared |
|
| printing. |
|
line termination | A string specifying the | Control |
| serial printing. This does not affect infrared printing. | characters |
| Note that control character 13 is the carriage return | 13 and 10. |
| and 10 is the line feed. |
|
|
|
|
Parameters without modified commands can be modified with a program by storing new values in the list contained in PRTPAR (use the PUT command).
Example: If the remapping string were “ABCDEFGH” and the character to be printed had value 131, then the character actually printed would be “D”, since
PTPAR
PTPAR is created when you use the Periodic Table, and it stores the current pointer position information.
STARTED
If it exists, the STARTED variable is evaluated when the