Installation and Getting Started Guide
Displaying PVST Information
To display PVST information, use the following CLI method.
USING THE CLI
To display PVST information for ports on an HP device, enter the following command at any level of the CLI:
HP 9304M or HP 9308M(config)# show span
VLAN | Port | PVST | PVST |
ID | Num. | Cfg. | On(by cfg. or detect) |
200 | 10 | 0 | 1 |
200 | 11 | 1 | 1 |
This example shows that for VLAN 200, PVST support is statically enabled on port 11. PVST is not statically enabled on Port 10, but because port 10 received an incoming PVST BPDU on its interface, the port converted to using PVST mode.
Syntax: show span
The show span
| Table 5.5: CLI Display of PVST Information | ||
|
|
| |
This Field... |
| Displays... | |
|
|
| |
VLAN ID |
| The VLAN to which the PVST/PVST+ information applies. | |
|
|
| |
Port Num. |
| The HP port number. | |
|
|
| |
PVST cfg. |
| Whether PVST support is statically enabled on the port. The value | |
|
| can be one of the following: | |
|
| • 0 | – The support has not been statically enabled. |
|
| • 1 | – The support has been statically enabled. |
|
|
| |
PVST on(by cfg. or detect) |
| Whether PVST/PVST+ support is active on the port. The value can | |
|
| be one of the following: | |
|
| • 0 | – PVST/PVST+ support is not enabled. |
|
| • 1 | – PVST/PVST+ support is enabled, either because you |
|
| statically enabled the support or because the port received an | |
|
| STP BPDU with PVST/PVST+ format. | |
|
|
|
|
USING THE WEB MANAGEMENT INTERFACE
You cannot display PVST information using the Web management interface.
5 - 22