Configuring SRP

USING THE CLI

To configure the IP sub-net VLAN with port membership of 1, 2, and 3, you would enter the following commands:

HP9300(config)# vlan 1

HP9300(config-vlan-1)# ip-subnet 192.147.200.0 255.255.255.0

HP9300(config-vlan-ip-subnet)# static e1 to 3

HP9300(config-vlan-ip-subnet)# router-int ve1

To enable SRP on virtual interface 1 and to configure ports 1, 2, 3, and 8 as its track ports, you would enter the following commands:

HP9300(config)# int ve1

HP9300(config-vif-1)# ip address 192.147.200.1 255.255.255.0

HP9300(config-vif-1)# ip srp address 192.147.200.1 vir-rtr 192.147.200.100 other-rtr 192.147.200.2

HP9300(config-vif-1)# ip srp addr 192.147.200.1 track port 1 2 3 8

To enable SRP on physical interface 8 and to configure ports 1, 2, and 3 as its track ports, you would enter the following commands:

HP9300(config)# int e8

 

 

HP9300(config-if-8)# ip

address 192.147.201.1 255.255.255.0

 

HP9300(config-if-8)# ip

srp address 192.147.201.1 vir-rtr 192.147.201.100

other-rtr 192.147.200.2

 

 

HP9300(config-if-8)# ip

srp addr 192.147.201.1 track port 1

2 3

HP9300(config-if-8)# end

 

 

HP9300# write memory

 

 

NOTE: After configuring track ports for Router 1, configure Router 2 similarly. This reciprocal configuration ensures that if Router 2 becomes the active router, it has track ports that support transfer to a SRP standby state.

NOTE: Virtual interfaces cannot be assigned as track ports.

USING THE WEB MANAGEMENT INTERFACE

You can select multiple track ports for SRP on the SRP configuration sheet.

13 - 15