Advanced Configuration and Management Guide
Saving Configuration Changes to the Interface
Once you have configured the cable range, network address, zone(s), and AppleTalk routing for an interface, you can preserve the configuration changes by saving them to flash.
HP9300# reload
NOTE: When there is more than one seed router on the network, make sure the AppleTalk configuration of each of those seed routers is consistent with other routers on the same segment.
USING THE WEB MANAGEMENT INTERFACE
This section describes how to enable AppleTalk on the routing switch as well as how to configure the cable range, network address, and zones for an AppleTalk seed router.
To enable AppleTalk on the routing switch:
1.Log on to the device using a valid user name and password for
2.Select the Enable radio button next to AppleTalk.
3.Click the Apply button to apply the changes to the device’s
4.Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change to the
To configure an interface as a seed router:
1.Log on to the device using a valid user name and password for
2.Click on the plus sign next to Configure in the tree view to expand the list of configuration options.
3.Click on the plus sign next to AppleTalk in the tree view to expand the list of AppleTalk option links.
4.Click on the Interface link to display the AppleTalk Interface table.
5.Click on the Modify button next to the interface you want to configure for AppleTalk. The AppleTalk Interface configuration panel is displayed, as shown in the following example.
6.Select the port or slot/port to be configured from the port pulldown menu(s).
7.Modify the ARP age value from the default value of 10 minutes, if desired. Possible values are 1 – 240 minutes.
15 - 6