HP 6308M-SX, 9304M, 9308M manual 329

Advanced Configuration and Management Guide

This Field...	Displays...
prune ports	Indicates the physical ports on which the routing switch has received a
	prune notification (in a Join/Prune message) to remove the receiver
	from the list of recipients for the group.
virtual prune ports	Indicates the virtual interfaces ports on which the routing switch has
	received a prune notification (in a Join/Prune message) to remove the
	receiver from the list of recipients for the group.

USING THE WEB MANAGEMENT INTERFACE

You cannot display the PIM multicast cache using the Web management interface.

Displaying PIM Traffic Statistics

To display PIM traffic statistics, use the following CLI method.

USING THE CLI

To display PIM traffic statistics, enter the following command at any CLI level:

HP9300(config-pim-router)# show ip pim traffic

Port		Hello			J/P	Register		RegStop			Assert
	[Rx		Tx]	[Rx	Tx]	[Rx	Tx]	[Rx	Tx]	[Rx	Tx]
e3/8	19		19	32	0	0	0	37	0	0	0
Port		Hello			J/P	Register		RegStop			Assert
	[Rx		Tx]	[Rx	Tx]	[Rx	Tx]	[Rx	Tx]	[Rx	Tx]
v1	18		19	0	20	0	0	0	0	0	0
Port		Hello			J/P	Register		RegStop			Assert
	[Rx		Tx]	[Rx	Tx]	[Rx	Tx]	[Rx	Tx]	[Rx	Tx]
v2	0		19	0	0	0	16	0	0	0	0
Total 37			57	32	0	0	0	0	0	0	0
IGMP Statistics:
Total		Recv/Xmit 85/110
Total		Discard/chksum			0/0

Syntax: show ip pim traffic

NOTE: If you have configured interfaces for standard PIM (dense mode) on the routing switch, statistics for these interfaces are listed first by the display.

This display shows the following information.

This Field...	Displays...
Port	The port or virtual interface on which the PIM interface is configured.
Hello	The number of PIM Hello messages sent or received on the interface.
J/P	The number of Join/Prune messages sent or received on the
	interface.
	Note: Unlike PIM dense, PIM Sparse uses the same messages for
	Joins and Prunes.
Register	The number of Register messages sent or received on the interface.

9 - 28