Configuring IP
1 current active tcbs, 4 tcbs allocated, 0 tcbs freed 0 tcbs protected 0 active opens, 0 passive opens, 0 failed attempts
0 active resets, 0 passive resets, 0 input errors
27 in segments, 24 out segments, 0 retransmission
Syntax: show ip traffic
The show ip traffic command displays the following information.
| Table 6.22: CLI Display of IP Traffic Statistics – switch | |
|
|
|
This Field... |
| Displays... |
|
|
|
IP statistics |
|
|
|
|
|
received |
| The total number of IP packets received by the device. |
|
|
|
sent |
| The total number of IP packets originated and sent by the device. |
|
|
|
fragmented |
| The total number of IP packets fragmented by this device to |
|
| accommodate the MTU of this device or of another device. |
|
|
|
reassembled |
| The total number of fragmented IP packets that this device re |
|
| assembled. |
|
|
|
bad header |
| The number of IP packets dropped by the device due to a bad packet |
|
| header. |
|
|
|
no route |
| The number of packets dropped by the device because there was no |
|
| route. |
|
|
|
unknown proto |
| The number of packets dropped by the device because the value in |
|
| the Protocol field of the packet header is unrecognized by this device. |
|
|
|
no buffer |
| This information is used by HP customer support. |
|
|
|
other errors |
| The number of packets that this device dropped due to error types |
|
| other than the types listed above. |
|
|
|
ICMP statistics |
|
|
The ICMP statistics are derived from RFC 792, “Internet Control Message Protocol”, RFC 950, “Internet Standard Subnetting Procedure”, and RFC 1256, “ICMP Router Discovery Messages”. Statistics are organized into Sent and Received. The field descriptions below apply to each.
total | The total number of ICMP messages sent or received by the device. |
|
|
errors | This information is used by HP customer support. |
|
|
unreachable | The number of Destination Unreachable messages sent or received |
| by the device. |
|
|
time exceed | The number of Time Exceeded messages sent or received by the |
| device. |
|
|
parameter | The number of Parameter Problem messages sent or received by the |
| device. |
|
|
source quench | The number of Source Quench messages sent or received by the |
| device. |
|
|
redirect | The number of Redirect messages sent or received by the device. |
|
|
6 - 103