Configuring IP
Table 6.8: CLI Display of Global IP Configuration Information – routing switch (Continued)
This Field... | Displays... | |
|
|
|
Policies |
|
|
|
| |
Index | The policy number. This is the number you assigned the policy when | |
| you configured it. | |
|
| |
Action | The action the routing switch takes if a packet matches the | |
| comparison values in the policy. The action can be one of the | |
| following: | |
| • deny – The routing switch drops packets that match this | |
|
| policy. |
| • permit – The routing switch forwards packets that match this | |
|
| policy. |
|
| |
Source | The source IP address the policy matches. | |
|
| |
Destination | The destination IP address the policy matches. | |
|
| |
Protocol | The IP protocol the policy matches. The protocol can be one of the | |
| following: | |
| • | ICMP |
| • | IGMP |
| • | IGRP |
| • | OSPF |
| • | TCP |
| • | UDP |
|
| |
Port | The Layer 4 TCP or UDP port the policy checks for in packets. The | |
| port can be displayed by its number or, for port types the routing | |
| switch recognizes, by the | |
| 80 can be displayed as HTTP. | |
| Note: This field applies only if the IP protocol is TCP or UDP. | |
|
| |
Operator | The comparison operator for TCP or UDP port names or numbers. | |
| Note: This field applies only if the IP protocol is TCP or UDP. | |
|
|
|
USING THE WEB MANAGEMENT INTERFACE
You cannot display global IP configuration information using the Web management interface.
Displaying IP Interface Information
To display IP interface information, use one of the following methods.
USING THE CLI
To display IP interface information, enter the following command at any CLI level:
HP9300(config)# show ip interface
Interface | OK? | Method | Status | Protocol | ||
Ethernet | 1/1 | 207.95.6.173 | YES | NVRAM | up | up |
Ethernet | 1/2 | 3.3.3.3 | YES | manual | up | up |
6 - 83