Getting Started

•Super Aggregated VLANs

•Support for simultaneous Telnet configuration by multiple users

•New CLI command for displaying dynamic memory utilization

•SNMP V2 view

•Enhancement to show default values command

•CLI enhancements to the startup-config and running-config files

•Page display is configurable for individual CLI management sessions

•CLI enhancement to display the idle time for open CLI sessions

•New CLI command for displaying TACACS+ or RADIUS information

•Enhancement to the show web command

•New option for setting the timeout for Telnet sessions

•Enhancements to show interface command

•ACL configuration supported in the Web management interface

•Greeting banners are displayed at the beginning of a Web management session

•Increasing the Syslog buffer size does not clear entries

•The newline character does not appear in Syslog and SNMP trap messages

•New MIB tables for Adaptive Rate Limiting

•Support for Secure Shell (SSH) for remote access to the CLI

•Support up to 12 trunk groups on 24-port 10/100 modules

•Strict ACL TCP mode

•Support for per-port ACL assignment within a virtual interface’s VLAN

•New commands for copying files between a device’s flash memory and a TFTP server

•Change to the IP address used when you enable the routing switch to use a single IP address on the device as the source for all Telnet, RADIUS, or TACACS/TACACS+ packets originated by the device

•Option to suppress Telnet connection rejection message

•Configurable block size for TFTP file transfers

Support and Warranty Information

Refer to Support is as Close as the World Wide Web, which was shipped with your HP switch or routing switch.

1 - 5