Advanced Configuration and Management Guide
This Field... | Displays... | |
|
| |
TTL Threshold | Following the TTL threshold value, the interface state is listed. The | |
| interface state can be one of the following: | |
| • | Disabled |
| • | Enabled |
|
| |
Local Address | Indicates the IP address configured on the port or virtual interface. | |
|
|
|
USING THE WEB MANAGEMENT INTERFACE
You cannot display PIM Sparse information using the Web management interface.
Displaying a List of Multicast Groups
To display a list of the IP multicast groups the routing switch is forwarding, use the following CLI method.
USING THE CLI
To display PIM Sparse configuration information, enter the following command at any CLI level:
Total number of Groups: 2 |
|
| |
Index 1 | Group 239.255.162.1 | Ports e3/11 | |
Syntax: show ip pim group |
|
| |
This display shows the following information. |
| ||
|
|
|
|
This Field... |
| Displays... |
|
|
| ||
Total number of Groups | Lists the total number of IP multicast groups the routing switch is | ||
|
| forwarding. |
|
|
| Note: This list can include groups that are not PIM Sparse groups. If | |
|
| interfaces on the routing switch are configured for regular PIM (dense | |
|
| mode) or DVMRP, these groups are listed too. | |
|
|
| |
Index |
| The index number of the table entry in the display. | |
|
|
| |
Group |
| The multicast group address | |
|
|
| |
Ports |
| The routing switch ports connected to the receivers of the groups. | |
|
|
|
|
USING THE WEB MANAGEMENT INTERFACE
You cannot display PIM Sparse information using the Web management interface.
Displaying BSR Information
To display information about the BSR, use the following CLI method.
USING THE CLI
To display BSR information, enter the following command at any CLI level:
PIMv2 Bootstrap information
This system is the elected Bootstrap Router (BSR)
BSR address: 207.95.7.1
Uptime: 00:33:52, BSR priority: 5, Hash mask length: 32
9 - 20