Configuring IP

In addition to the information described below, you can display the following IP information. This information is described in other parts of this guide.

•RIP information – see “Displaying RIP Filters” on page 7-16.

•OSPF information – see “Displaying OSPF Information” on page 8-39.

•BGP4 information – see “Displaying BGP4 Information” on page 10-84.

•DVMRP information – see the “Show Commands” chapter in the Command Line Interface Reference.

•PIM information – see the “Show Commands” chapter in the Command Line Interface Reference.

•VRRP or VRRPE information – see “Displaying VRRP and VRRPE Information” on page 12-19.

•SRP information – see the “Show Commands” chapter in the Command Line Interface Reference.

Displaying Global IP Configuration Information

To display global IP configuration information for the routing switch, use one of the following methods.

USING THE CLI

To display IP configuration information, enter the following command at any CLI level:

HP9300> show ip

Global Settings

 

 

 

 

 

 

 

ttl: 64, arp-age: 10, bootp-relay-max-hops: 4

 

 

 

router-id : 207.95.11.128

 

 

 

 

 

 

enabled

: UDP-Broadcast-Forwarding

IRDP Proxy-ARP RARP OSPF

 

disabled: BGP4 Load-Sharing RIP

DVMRP

SRP VRRP

 

 

 

Static Routes

 

 

 

 

 

 

 

Index

IP Address

Subnet Mask

Next Hop Router

Metric Distance

1

0.0.0.0

 

0.0.0.0

 

209.157.23.2

1

1

Policies

 

 

 

 

 

 

 

 

Index

Action

Source

 

Destination

Protocol

Port

Operator

1

deny

209.157.22.34

209.157.22.26

tcp

http

=

64

permit

any

 

any

 

 

 

 

Syntax: show ip

NOTE: This command has additional options, which are explained in other sections in this guide, including the sections below this one.

6 - 81