Installation and Getting Started Guide
Loopback 1 | 1.2.3.4 | YES NVRAM | down | down |
Syntax: show ip interface [ethernet <portnum>] [loopback <num>] [ve <num>]
This display shows the following information.
| Table 6.9: CLI Display of Interface IP Configuration Information | |
|
|
|
This Field... |
| Displays... |
|
|
|
Interface |
| The type and the slot and port number of the interface. |
|
|
|
| The IP address of the interface. | |
|
| Note: If an “s” is listed following the address, this is a secondary |
|
| address. When the address was configured, the interface already had |
|
| an IP address in the same |
|
| “secondary” option before the software could add the interface. |
|
|
|
OK? |
| Whether the IP address has been configured on the interface. |
|
|
|
Method |
| Whether the IP address has been saved in NVRAM. If you have set |
|
| the IP address for the interface in the CLI or Web Management |
|
| interface, but have not saved the configuration, the entry for the |
|
| interface in the Method field is “manual”. |
|
|
|
Status |
| The link status of the interface. If you have disabled the interface with |
|
| the disable command, the entry in the Status field will be |
|
| “administratively down”. Otherwise, the entry in the Status field will be |
|
| either “up” or “down”. |
|
|
|
Protocol |
| Whether the interface can provide |
|
| address is configured, and the link status of the interface is up, the |
|
| entry in the protocol field will be “up”. Otherwise the entry in the |
|
| protocol field will be “down”. |
|
|
|
USING THE WEB MANAGEMENT INTERFACE
To display IP interface information:
1.Log on to the device using a valid user name and password for
2.Click on the plus sign next to Configure in the tree view.
3.Click on the plus sign next to IP in the tree view to expand the list of IP option links.
4.Click on the Interface link to display the IP interface table.
6 - 84