Advanced Configuration and Management Guide

Syntax: deny permit redistribute <filter-num> all bgp connected rip static [address <ip-addr> <ip-mask> [match-metric <value> [set-metric <value>]]]

EXAMPLE:

To redistribute RIP, static, and BGP4 routes into OSPF, enter the following commands on the routing switch acting as an ASBR:

HP9300ASBR(config)# router ospf

HP9300ASBR(config-ospf-router)# permit redistribute 1 all

HP9300ASBR(config-ospf-router)# write memory

Syntax: deny permit redistribute <filter-num> all bgp connected rip static address <ip-addr> <ip-mask>

[match-metric <value> set-metric <value>]

NOTE: Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the example above is shown for clarity but is not required.

You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as specifying that only routes for a specific network or with a specific cost (metric) be imported, as shown in the command syntax below:

Syntax: [no] redistribution bgp connected rip static

For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following commands.

HP9300(config)# router ospf

HP9300(config-ospf-router)# redistribution rip

HP9300(config-ospf-router)# redistribution static

HP9300(config-ospf-router)# write memory

NOTE: The redistribution command does not perform the same function as the permit redistribute and deny redistribute commands. The redistribute commands allow you to control redistribution of routes by filtering on the IP address and network mask of a route. The redistribution commands enable redistribution for routes of specific types (static, directly connected, and so on). Configure all your redistribution filters before enabling redistribution.

NOTE: Do not enable redistribution until you have configured the redistribution filters. If you enable redistribution before you configure the redistribution filters, the filters will not take affect and all routes will be distributed.

USING THE WEB MANAGEMENT INTERFACE

1.Log on to the device using a valid user name and password for read-write access. The System configuration panel is displayed.

2.Click on the plus sign next to Configure in the tree view to expand the list of configuration options.

3.Click on the plus sign next to OSPF in the tree view to expand the list of OSPF option links.

4.Click on the Redistribution Filter link.

•If the device does not have any OSPF redistribution filters, the OSPF Redistribution Filter configuration panel is displayed, as shown in the following example.

•If an OSPF redistribution filter is already configured and you are adding a new one, click on the Add Redistribution Filter link to display the OSPF Redistribution Filter configuration panel, as shown in the following example.

5.If you are modifying an existing OSPF redistribution filter, click on the Modify button to the right of the row describing the filter to display the OSPF Redistribution Filter configuration panel, as shown in the following example.

8 - 26