Advanced Configuration and Management Guide

5.Enter the VLAN ID that will contain the AppleTalk cable VLAN in the VLAN ID field.

6.Enter a name for the VLAN in the Protocol_VLAN_Name field.

7.Select the virtual interface from the Router_Interface pulldown list if you configured a virtual interface for routing into and out of the VLAN.

8.Select the AppleTalk cable ID from the AppleTalk Cable field’s pulldown list.

9.Specify the port that are members for the VLAN:

Select Dynamic Port if you want the port membership to be dynamic. For information, see “Dynamic Ports” on page 16-9.

Click the Change Static Members button if you want to configure static ports. For information, see “Static Ports” on page 16-10.

Click the Change Exclude Members button if you want to explicitly exclude some ports. For information, see “Excluded Ports” on page 16-10.

NOTE: All the ports must be members of the port-based VLAN that contains this AppleTalk cable VLAN. See “Layer 3 Protocol-Based VLANs” on page 16-3.

10.Click the Add button (if you are adding a new VLAN) or the Modify button (if you are modifying an existing VLAN) to save the change to the device’s running-config file.

11.Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change to the startup-config file on the device’s flash memory.

NOTE: You also can access the dialog for saving configuration changes by clicking on Command in the tree view, then clicking on Save to Flash.

16 - 56