Configuring VRRP and VRRPE

Table 12.2: CLI Display of VRRP or VRRPE Summary Information (Continued)

This Field...

Displays...

 

 

Master addr

The IP address of the router interface that is currently the Master for

 

the VRID.

 

 

Backup addr

The IP addresses of the router interfaces that are currently Backups

 

for the VRID.

 

 

VIP

The virtual IP address that is being backed up by the VRID.

 

 

USING THE WEB MANAGEMENT INTERFACE

You cannot display the summary view using the Web management interface. Use the Web management procedure in “Displaying Detailed Information”.

Displaying Detailed Information

To display detailed VRRP or VRRPE information, use either of the following methods.

USING THE CLI

To display detailed information for a routing switch, enter the following command at any level of the CLI:

HP9300(config)# show ip vrrp

Total number of VRRP routers defined: 1 Interface ethernet 1/6

auth-type no authentication VRID 1

state master administrative-status enabled mode owner

priority 255

current priority 255 hello-interval 1 sec advertise backup: disabled track-port 2/4

This example is for a VRRP Owner. Here is an example for a VRRP Backup.

HP9300(config)# show ip vrrp

Total number of VRRP routers defined: 1 Interface ethernet 1/5

auth-type no authentication VRID 1

state backup administrative-status enabled mode non-owner(backup) priority 100

current priority 100 hello-interval 1 sec dead-interval 3.600 sec current dead-interval 3.600 sec preempt-mode true

advertise backup: enabled

backup router 192.53.5.3 expires in 00:00:03 next hello sent in 00:00:02

track-port 3/2

12 - 21