Advanced Configuration and Management Guide

USING THE WEB MANAGEMENT INTERFACE

You cannot configure PIM Sparse parameters using the Web management interface.

Displaying PIM Sparse Configuration Information and Statistics

You can display the following PIM Sparse information:

•Basic PIM Sparse configuration information

•Group information

•BSR information

•Candidate RP information

•RP-to-group mappings

•RP information for a PIM Sparse group

•RP set list

•PIM Neighbor information

•The PIM flow cache

•The PIM multicast cache

•PIM traffic statistics

Displaying Basic PIM Sparse Configuration Information

To display basic configuration information for PIM Sparse, use the following CLI method.

USING THE CLI

To display PIM Sparse configuration information, enter the following command at any CLI level:

HP9300(config-pim-router)# show ip pim sparse

Global PIM Sparse Mode Settings

Hello interval: 60, Neighbor

timeout: 180

Bootstrap Msg interval: 130,

Candidate-RP Advertisement interval: 60

Join/Prune interval: 60, SPT

Threshold: 1

Interface Ethernet e3/8

 

TTL Threshold: 1, Enabled

 

Local Address: 207.95.8.1

 

Interface Ve 1

TTL Threshold: 1, Enabled

Local Address: 207.95.6.1

Syntax: show ip pim sparse

This example shows the PIM Sparse configuration information on PIM Sparse router A in Figure 9.3.

9 - 18