HP Application Recovery Manager Cell Manager Windows Media Kit manual TargettreeTargetTreeName

Throttles down the consistency check to lessen impact on restore performance. Set the number of input/output operations, after which the check is stopped for one second.

Exchange_2007_Specific_Options

-appsrvClientName

Specifies the system to which the components are restored. If not specified, the components are always restored to the server from where they were backed up. Note that all objects in one restore session must be restored to the same system.

-target_treeTargetTreeName

Specifies the target component to which the source component will be restored and enables you to restore a subcomponent to a different component than the one from which it was backed up. This option can be used only once for each -treeoption and cannot be specified together with -exch_RSG.

TreeName and its TargetTreeName pair must always be fully expanded subcomponents representing an Exchange store or logs. See also the Exchange 2007 examples. To get a list of available targets on a specific host, run the command:

vssbar -appsrv:HostName-perfom:browse -all

Potential targets can be identified by the string “RESTOREMODE = 1”.

NOTE: You cannot restore only a store without logs to a different location. If you specify a target store for an original store, you must also specify logs with an additional -treeTreeName -target_treeTargetTreeName pair. This limitation does not apply if you restore only the logs to a different location.

The option must be specified together with -target_dir.

-exch_RSGRSGTreeName

Creates a new Recovery Storage Group (RSG) and links it to RGSTreeName. This option can be used only once for each -treeoption and cannot be specified together with -target_tree. Only one storage group per session can be restored with this option due to an Exchange limitation. RSGTreeName and its TreeName pair must always be fully expanded subcomponents, representing an Exchange store or logs. See also the Exchange 2007 examples.

IMPORTANT: If the RSG already exists, it is removed and a new one is created.

Any existing data in it will be lost. NOTE: You cannot restore only a store without logs to a different location. If you specify a target store for an original store, you must also specify logs with an additional -treeTreeName -target_treeTargetTreeName pair. This limitation does not apply if you restore only the logs to a different location.

The option must be specified together with -target_dir.

Command line interface reference 75