*LRN?

*LRN?

*LRN? returns a sequence of commands that may be re-sent to the HP E1429 to return it to its current programming state.

Only those commands that are affected by *RST are included in the sequence. Exceptions include MEMory:BATTery:STATe, the STATus subsystem commands, and the CALibration:SECurity command state.

Note *LRN? should be sent singly in a program message, since the number of commands in the returned sequence is large, and may vary depending on firmware revision.

Comments Executable when initiated: Yes

Coupled command: No

Related commands: *RCL, *RST, *SAV

*RST Condition: none

*OPC

*OPC causes the HP E1429 to wait for all pending operations to complete. The Operation Complete bit (bit 0) in the Standard Event Status Register is then set.

If STATus:OPC:INITiate OFF is set, the Operation Complete bit will be set when all commands received prior to the *OPC have been executed. If ON is set, *OPC waits for the digitizer to return to the idle state before setting the Operation Complete bit. No other commands will be executed until the Operation Complete bit is set.

Comments Executable when initiated: Yes

Coupled command: No

Related commands: *OPC?, *WAI

*RST Condition: none

303 Command Reference

Chapter 4

Page 303
Image 303
HP E1429A manual Lrn?, Opc