HP E1429A manual Command Quick Reference Chapter

Table 4-1. HP E1429A/B Command Quick Reference.

Subsystem	Commands	Description
ARM	ARM[:STARt]:COUNt <count >	Specifies the number of measurement
		cycles (bursts) to occur.
	ARM[:STARt]:DELay <period >	Delay from when the digitizer is armed to
		when it enters the wait-for- trigger state.
	ARM[:STARt][:IMMediate]	Places the digitizer in the wait-for-trigger
		state, independent of the selected
		ARM:STARt:SOURce.
	ARM[:STARt]:LEVel[<chan >]:NEGative <voltage >	Selects the (negative-going) signal level
		which arms the digitizer.
	ARM[:STARt]:LEVel[<chan >]:POSitive <voltage >	Selects the (positive-going) signal level
		which arms the digitizer.
	ARM[:STARt]:SLOPe[<n >] <edge >	Selects the edge: positive, negative, or
		either, which will arm the digitizer.
	ARM[:STARt]:SOURce[<n >] <source >	Sets the digitizer arm source.
CALibration	CALibration[<chan >]:COUNt?	Returns a number that indicates how often
		the digitizer has been calibrated.
	CALibration[<chan >]:DATA <block_data >	Manually sets or queries the calibration
		constants.
	CALibration[<chan >]:DELay	Calibrates the A/D converter delay constant.
	CALibration[<chan >]:GAIN [<readings >	Performs a gain calibration using the
	[,<period >[,<flag >]]]	specified number of readings and sample
		rate.
	CALibration[<chan >]:SECure:CODE <code >	Sets the code required to disable
		calibration security.
	CALibration[<chan >]:SECure:STATe <mode > [,<code >]	Enables/disables calibration security.
	CALibration[<chan >]:STORe	Stores the currently selected channel’s
		calibration constants into non-volatile
	CALibration[<chan >]:STORe:AUTO <mode >	memory.
		Selects whether or not calibration constants
	CALibration[<chan >]:VALue <number >	will be automatically stored.
		Specifies the voltage level at the input.
	CALibration[<chan >]:ZERO [<readings >
		Performs a calibration of the zero offset.
	[,<period >,[<mode >]]]
CONFigure	CONFigure[<chan >]:ARRay[:VOLTage][:DC] (<size>)	Configures the digitizer for <size> number
	[,<expected value >[,<resolution >]]	of readings on the specified channel and
	[,(@<input port>)]	input port.
DIAGnostic	DIAGnostic:CALibration[<chan >]:CONVerge?	Returns convergence data from the latest
		CAL:ZERO or CAL:GAIN.
	DIAGnostic:CALibration[<chan >]:GAIN:SENSitivity?	Returns the sensitivity constant used during
		the last CAL:GAIN command.
	DIAGnostic:CALibration[<chan >]:ZERO:SENSitivity?	Returns the sensitivity constant used during
		the last CAL:ZERO command.
	DIAGnostic:CHANnel[<chan >]:LABel <label >	Sets the bit pattern (label) specified on the
		four least significant bits of the reading.

310 Command Quick Reference Chapter 4