HP E1429A manual Rmc, Rst

*RMC

∙*RST Condition: all saved states set to the same state as the *RST state

*RMC

*RMC <name> purges only the specified macro definition.

NOTE: At printing time, *RMC is a command proposed and accepted for a revision and re-designation of IEEE-488.2.

Comments ∙ Use the *PMC command to purge all macro definitions in one command.

∙Executable when initiated: Yes

∙Coupled command: No

∙Related commands: *DMC, *PMC

∙*RST Condition: none

*RST

*RST resets the HP E1429 as follows:

∙Sets all commands to their *RST state.

∙Aborts all pending operations including VME bus or Local bus transfers.

∙Loads calibration constants from non-volatile calibration memory.

*RST does not affect:

∙The state of VXIbus word serial protocol

∙The output queue

∙The Service Request Enable Register

∙The Standard Event Status Enable Register

∙The enable masks for the OPERation Status and Questionable Signal registers

∙Calibration security state

∙Protected user data

∙The memory backup battery

Comments ∙ Executable when initiated: Yes

∙Coupled command: No

∙*RST Condition: none

Chapter 4 Command Reference 306