HP E1429A manual Appendix B Useful Tables

Table B-3. HP E1429A/B Error Messages (Cont’d)

Code	Message	Description
-410	Query INTERRUPTED	The digitizer was sent a command before it was
		finished responding to a query command.
-420	Query UNTERMINATED	The controller (computer) attempts to read a query
		response from the digitizer without having first sent a
		complete query command.
-430	Query DEADLOCKED	The digitizer’s input and output buffers are full and the
		digitizer cannot continue.
-440	Query UNTERMINATED after	Occurs when the *IDN? query is not the last query
	indefinite response	executed in a command string.
1002	Cal security enabled	Calibration security must be disabled to calibrate the
		digitizer, to read or write calibration data, to change
		the security code, or to change the protected user
		data.
1004	Cal write fail	Writing calibration or protected user data (*PUD) to
		nonvolatile memory failed.
1005	Error during CAL	An error occurred during calibration. Refer to the
		statement appended to this message for a description
		of the error.
1007	Calibration security defeated	A jumper was moved to defeat calibration security.
1008	Error during zero cal	An error occurred during calibration of the zero offset.
		Refer to the statement appended to this message for
		a description of the error.
1009	Error during gain cal	An error occurred during gain calibration. Refer to the
		statement appended to this message for a description
		of the error.
1010	Error during linearity cal	An error occurred during linearity calibration. Refer to
		the statement appended to this message for a
		description of the error.
1015	A/D control register not responding	The serial interface register was not working properly
		at power-on.
1016	Illegal during LBUS or VME	The command can not be executed while a VME bus
	memory transfer	or Local bus data transfer is in progress.
1017	Battery too low, data may be lost	The battery does not contain sufficient charge to
		maintain memory over an extended period. This error
		occurs when readings are taken, when the battery is
		enabled/disabled, or during the self-test.
1018	Battery backed data corrupt	This error is due to a low battery charge, or if the
		battery is enabled after readings are in memory.

Appendix B Useful Tables 339