HP E1429A manual Scpi

R

Rate, arm, 118 Re-initiating the digitizer, 378

READ? subsystem, retrieving readings, 139 Reading and writing to the shift register, 369 Reading resolution, 136

Reading the data register, 153 Readings, locating in memory, 142 Readings, transfer rates, 137 Recalling digitizer configurations

*RCL, 175 Reference clock, 124 Reference source

setting, 124 Register descriptions

arm count, 374 arm delay, 360 arm source, 373

Register interface, 105 Register programming

aborting measurements, 377 setting the arm count, 374 setting the arm delay, 374 setting the arm source, 373

Register-based programming

example program system configuration, 341 Registers

arm count, 374 arm delay, 360 arm source, 373

Removing the arbitrary block header, 135 Reset configuration, 25

Resetting and clearing the digitizer, 23 Resolution, reading, 136 Retrieving readings using DIAGnostic:UPLoad:SADDress?, 141 Retrieving readings using READ?, 139

Retrieving readings with the FETCh? subsystem, 139 Retrieving readings, determining the number of, 140 Retrieving readings, methods, 137

Retrieving readings, transfer speeds, 137 Routing the signal to a source, 120, 128

S

Safety warnings, 10 Sample period

description, 122 setting, 122

Sampling

dual rate, 123

Saving digitizer configurations, 174 *SAV, 175

SCPI

Conformance Information, 314 SCPI command control

input section, 106 SCPI command coupling, 182 SCPI command execution, 182 SCPI command listings

as found in the manual, 28 SCPI command parameters, 180 SCPI Commands, 177

Format, 179 Reference, 184

SCPI Conformance Information, 314 SCPI programming, 28

SCPI programming, introduction, 33 Segmented memory, 131 Segmented Reading transfers, 153 Segmented readings, where they are stored, 143 Selecting the input port, 107

Self-test, digitizer, 21

Sending an immediate trigger, 125 Sending commands to the digitizer, 105 Sending the *IDN? command, 20

SENSe, and TRIGger subsystems overview, 121 Separating pre- and post-arm readings, 140 Separator

Command, 179 Setting the arm count, 117

Setting the arm count, procedure, 374 Setting the arm delay, 117

Setting the arm delay, procedure, 375 Setting the arm level, 116

Setting the arm signal slope, 115 Setting the arm source, 114

Setting the arm source, procedure, 373 Setting the input impedance, 108

Setting the input impedance, register-based, 370 Setting the interleaved transfer mode, 406 Setting the Local bus data source, 163 Setting the Local bus transfer mode, 162

Setting the measurement range, register-based, 370 Setting the pre-arm reading count, 125

Setting the reference source, 124 Setting the signal range, 109 Setting the trigger count, 125 Setting the trigger source, 121 Setting the VME bus data source, 152 Setting the VME bus transfer mode, 151 Settings, querying, 43

Shift register, reading and writing, 369 Shift register, using, 368

HP E1429A/B User’s Manual Index - 419