10.Enter the sr command to view the system revision information. A sample output for a BL890c i4 is shown below. The BL890c i4 will show four blades composing the server blade, a BL870c i4 will show two. If the output does not show all of the blades expected, then there is a problem which must be resolved before proceeding. Reseating the Blade Link or individual blades may correct server blade conjoining problems.
[ilo002264fed1da] CM:hpiLO-> sr
SYSREV |
|
|
|
|
|
|
Revisions | Active | Pending | Bay 5 | Bay 6 | Bay 7 | Bay 8 |
iLO FW | : | 01.30.30 | 01.30.30 | 01.30.30 | 01.30.30 | 01.30.30 |
System FW | : | 01.24 | 01.24 | 01.24 | 01.24 | 01.24 |
MHW FPGA | : | 01.14 | 01.14 | 01.14 | 01.14 | 01.14 |
Power Mon FW | : | 03.04 | 03.04 | 03.04 | 03.04 | 03.04 |
Front Panel HW : | 03.00 | 03.00 | 03.00 | 03.00 | 03.00 | |
PRS HW | : | 02.07 | 02.07 | 02.07 | 02.07 | 02.07 |
IOH HW | : | 02.02 | 02.02 | 02.02 | 02.02 | 02.02 |
NOTE: This is just an example so actual version numbers may be different from what is shown.
11.If the sr output indicates that the firmware is not consistent across all of the blades, which should only be due to a new Upgrade Blade with different firmware version being added, then complete a second server firmware update. Update the system to the same firmware version used previously for the existing servers. An example of sr output indicating a firmware inconsistency is shown below.
[ilo002264fee2de]
SYSREV |
|
|
|
|
|
|
Revisions | Active | Pending | Bay 5 | Bay 6 | Bay 7 | Bay 8 |
iLO FW | : | ! | 01.30.29 | 01.30.29 | 01.01.02 | 01.01.02 | |
System FW | : | ! | 01.24 | 01.24 | 01.08 | 01.08 | |
MHW FPGA | : | ! | 01.14 | 01.14 | 01.12 | 01.12 | |
Power Mon FW | : | 03.04 |
| 03.04 | 03.04 | 03.04 | 03.04 |
Front Panel HW : | 03.00 |
| 03.00 | 03.00 | 03.00 | 03.00 | |
PRS HW | : | 02.07 |
| 02.07 | 02.07 | 02.07 | 02.07 |
IOH HW | : | 02.02 |
| 02.02 | 02.02 | 02.02 | 02.02 |
Note(s):
! = FW mismatch, update needed
