Table 11 Indications for the iLO 3 TUI LEDs (continued)
| NOTE: If the SYSTEM LED lights red, |
| this counts as a FRU failure for the |
| HEALTH LED. |
Flashing | Health of the partition is FATAL and the |
red | health of one or more blades within the |
| partition are FATAL, meaning that: |
| • A FRU has failed and A fatal event has |
| been logged (Level seven events cause |
| this indication if there are FRU failures |
| on one of the blades in the partition.) |
| A reset will clear this LED of a fatal event, |
| but not a FRU failure. A power cycle will |
| clear both. |
Steady | All internal FRUs in the partition are |
green | healthy, there are no fatal events, and the |
| system power is on. |
Off | Power to the system/partition is off and |
| there were no AMBER or RED HEALTH |
| indications on the last boot. |
SYSTEM | There is only one |
| SYSTEM LED per |
| partition. The state will |
| be the same for every |
| blade in the partition. |
•System Event Log Health as displayed on the System Health page in the iLO 3
GUI
•There is no physical LED on the blade's front panel that represents this state.
Flashing | There has been a FATAL event since the |
red | last power on or system reset. |
| A reset or power on will clear this LED. |
Steady | System is beginning to boot the OS |
green |
|
Off | OS is not booting and there are no fatal |
| events. |
LOCATOR Identifies the system/partition and will blink while a firmware update is in progress.
NOTE: All blades in a partition show the same LOCATOR status at all times.
NOTE: You can toggle the UID in software from either the iLO 3 TUI or web GUI. There is no UID hardware button on the server blade itself to turn it on or off.
•UID LED on the front panel of the individual blade
•Locator UID in iLO 3
•Virtual Indicator in the Onboard Administrator’s interface
On | The system/partition is identified. |
Off | System/partition is not identified and no |
| firmware update is actively writing to any |
| of the system ROMs |
Flashing | Power should not be interrupted; firmware |
| is actively burning a ROM. |
| NOTE: On ProLiant servers this LED |
| blinks to indicate remote management; |
| however this is not currently a supported |
| indication on Integrity servers. |
ON/OFF | Toggles the current LED state to indicate |
toggle | transitional mode states activated by a |
| push and hold of the Physical Presence |
| button. |
| If the Locator is off it will toggle on and |
| then off, but if the Locator is on, it will |
| toggle off and then on. If the Locator is |
| flashing, no action will be taken. |
POWER | Identifies the |
| system/partition power |
| state. |
•Monarch Power button LED on the front panel of the Monarch blade
•System Power LED in the iLO 3 GUI
Steady | System/partition is fully powered on. |
green |
|
Steady | System/partition is in standby. |
amber |
|
Off | The system/partition is powered off. |
90 Troubleshooting
