IBM Remote Supervisor Adapter II manual Setting system information

–TCP command mode protocol

–Service location protocol

v From the Security page, you can install and configure the Secure Sockets Layer (SSL) settings.

vFrom the Configuration File page, you can back up, modify, and restore the configuration of the Remote Supervisor Adapter II.

vFrom the Restore Defaults page, you can reset the Remote Supervisor Adapter II configuration to the factory defaults.

vFrom the Restart ASM page, you can restart the Remote Supervisor Adapter II.

Setting system information

To set the Remote Supervisor Adapter II system information, complete the following steps:

1.Log in to the Remote Supervisor Adapter II where you want to set the system information. For more information, see Chapter 2, “Opening and using the Web interface,” on page 5.

2.In the navigation pane, click System Settings. A page similar to the one in the following illustration is displayed.

Note: The available fields in the System Settings page are determined by the accessed remote server.

3.In the Name field in the ASM Information area, type the name of the Remote Supervisor Adapter II.

Use the Name field to specify a name for the Remote Supervisor Adapter II in this server. The name is included with e-mail, SNMP, and alphanumeric pager alert notifications to identify the source of the alert.

Notes:

a.If you plan to set up an SMTP server for e-mail alert notifications, make sure that the name in the Name field is valid as part of an e-mail address (for example, there are no spaces).

b.Your Remote Supervisor Adapter II name (in the Name field) and the IP host name of the Remote Supervisor Adapter II (in the Host Name field on the Network Interfaces page) do not automatically share the same name because the ASM Name field is limited to 15 characters. The Host Name

12 Remote Supervisor Adapter II SlimLine and Remote Supervisor Adapter II: User’s Guide