IBM Remote Supervisor Adapter II manual Setting local events, System alerts

System alerts

System alerts are generated for events that occur as a result of system errors. If the Select all system alerts check box is selected, an alert can be sent for any system alert.

Notes:

a.The Select all system alerts check box is not available on all servers.

b.Hard disk drive Predictive Failure Analysis (PFA) alerts are not monitored.

Table 4. System remote alerts

Alphanumeric	Alphanumeric
pager code	recovery code	Event	Action
20	70	POST timeout	Generates an alert if an enabled POST timeout value is
			exceeded. The POST timeout value is configured in the
			Server Timeouts area on the System page.
21	71	O/S timeout	Generates an alert if an enabled operating system timeout
			value is exceeded. The operating system timeout value is
			configured in the Server Timeouts area on the System
			page. The O/S timeout alert must be checked to enable
			remote operating-system-failure screen capture.
22	72	Test alert	Generates an alert if the Generate Test Alert button is
			clicked on the Remote Alert Recipients page.
23	73	Power off	Generates an alert if the server is turned off.
24	74	Power on	Generates an alert if the server is turned on.
25	75	Boot failure	Generates an alert if an error occurs that prevents the
			server from starting.
26	76	Loader timeout	Generates an alert if an enabled server loader timeout value
			is exceeded. The system loader timeout value is configured
			in the Server Timeouts area on the System page.
27	77	PFA notification	Generates an alert if a PFA notification is generated by the
			server hardware. This feature is available only on servers
			that have PFA-enabled hardware.
28 - 29			Reserved for future use.
38	88	Partition	Generates an alert if a partition configuration notification is
		configuration	generated by the server. This feature is available only on
			servers that have partitionable hardware.
39	89	Event log	Generates an alert if the event log reaches 75% or 100% of
			capacity, or if the log is cleared (Refresh 2 or later firmware
			only).

4. Scroll to the bottom of the page and click Save.

Setting local events

Note: For the Remote Supervisor Adapter II SlimLine, the setting local events feature is available only when using LAN-based alert functionality.

Complete the following steps to select the local events to which the Remote

Supervisor Adapter II will respond:

Chapter 3. Configuring the Remote Supervisor Adapter II 29