
Reinstalling the Controller Card
Use the following procedure to reinstall the controller card:
1. Place the controller card | into | the | guide channels at the top and | bottom of | the b | ||
opening. Slide the | controller | card back into | the printer. Note that | the latches | click | ||
when the controller | card is | in | the | correct | position. |
|
|
2.Tighten the thumbscrews at the top and bottom of the controller card mounting bracket.
3. Connect the power cord to the back of the printer.
4. Connect the other end of the power cord to a grounded AC outlet.
5. Switch the printer power on.
6. After the printer warms up, the READY message displays on the operator panel.
Note: | If | the | message | display | area | shows solid rectangles, reseat the card. | ||||||||||
7. To confirm that you have correctly | installed | a memory | SIMM, | hard | drive, | data | ||||||||||
stream | SIMM, | or any | combination, | a configuration page. The report | will list | |||||||||||
the features if they have been correctly installed. See “Printing the Printer | ||||||||||||||||
Configuration | Page” | on | page 13. |
|
|
|
|
|
|
|
|
|
| |||
Note: | If | the | options | do not appear | for | the | SIMM | or | hard | drive, | remove | the | ||||
controller card, make sure that the | SIMM | or hard | drive is | correctly | seated, and | |||||||||||
reinstall | the |
| controller | card. |
|
|
|
|
|
|
|
|
|
|
8.Make sure you update your printer driver to indicate the new DRAM SIMM, PostScript SIMM, IPDS SIMM, Flash Memory SIMM, or hard drive is installed.