Twinax Setup Menu
Use the Twinax Setup menu to configure the Twinax attachment. The following table
describes the | settings you can change from | the Twinax Setup Menu. An asterisk (*) | ||||||||||||
next to a value in the table indicates the | factory default. The Twinax Setup Menu | |||||||||||||
appears | only | if | you | have the twinax | attachment | installed. |
|
|
|
|
|
| ||
Notes: |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1. To | select a | new | value, Continue/Enterpress the | key when | the | value | is | displayed |
|
| ||||
in the message display area. An asterisk | (*) | appears next | to | the | value | in | the | |||||||
message display area, indicating that it | is | now | active. |
|
|
|
|
|
| |||||
Important! | If | you change SCS ADDR or IPDS | ADDR, you must | power | off | the |
|
| ||||||
printer, wait ten seconds, and then power | on | the | printer | for | the | new | value | to take | ||||||
effect. |
|
|
|
|
|
|
|
|
|
|
|
|
| |
2.For more information about configuring the twinax IBMattachment,Network see Printers: Twinax/Coax Configuration. Guide
|
| 3. If you are unfamiliar | with using | the operator | panel to | work | with | menus, | please re | ||
|
| “Using | the Operator Panel Keys” on page 10 and “Navigating Menus” on page 12 | ||||||||
|
| before | continuing. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
TWINAX | SETUP | VALUE |
| Description |
|
|
|
|
|
| |
MENU | ITEM |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
SCS ADDR | OFF* | The twinax | hardware | address of the | SCS port. | n can | be | from 0 | to | ||
|
| n | 6. |
|
|
|
|
|
|
|
|
|
|
| Notes: |
|
|
|
|
|
|
|
|
1.SCS ADDR and IPDS ADDR cannot be set to the same value.
2. | If you change SCS | ADDR | or | IPDS ADDR, | you | must | power | |||||
| off the printer, wait ten seconds, | and then power on the | ||||||||||
| printer | for | the new | value | to | take | effect. |
|
| |||
3. | When | the optional IPDS SIMM is | installed, each | IBM | ||||||||
| Network | Printer can act as two | separate printers on the same | |||||||||
| twinax | port. (The printer cannot be attached to two different | ||||||||||
| twinax | systems | using | the | same | twinax | card.) | One | “printer” | |||
| prints | SCS data to one address | (SCS ADDR), and the other | |||||||||
| prints | IPDS | to | another address | (IPDS | ADDR). |
|
| ||||
