IBM S544-5343-03 manual Ipds Addr EDGE-EDGE OFF

TWINAX

SETUP

VALUE

Description

MENU

ITEM

IPDS

ADDR

OFF*

The

twinax

hardware

address

of

the

IPDS

port.

n

can

be

from 0

n

to

6.

Notes:

1. SCS

ADDR and IPDS ADDR

cannot

be

set

to

the

same

value.

2. If

you

change

SCS

ADDR

or IPDS

ADDR,

you

must

power

off

the

printer,

wait

ten

seconds,

and

then

power

on

the

printer

for

the

new

value

to

take effect.

3. When

the optional IPDS

SIMM

is

installed,

each

IBM

Network

Printer

can act

as

two separate printers on the same

twinax

port. (The printer cannot be attached to two different

twinax

systems

using

the

same

twinax

card.)

One

“printer”

prints

SCS

data

to

one

address (SCS ADDR), and the other

prints

IPDS

to

another

address

(IPDS

ADDR).

EDGE-EDGE

OFF*

Turns

edge-to-edge

printing

on

or

off.

ON

Ÿ

OFF—the

printer

maintains

a

no-print

border

of

4

mm on

all

four

paper

sides.

ŸON—The printer allows printing up to the physical page size.

Notes:

1.To avoid toner contaminating the printer, IBM recommends leaving EDGE-EDGE set to OFF; use ON only when necessary.

2.The Twinax Setup Menu item EDGE-EDGE applies to SCS

		data only. To specify				edge-to-edge printing	for	IPDS	data,
		use the EDGE-EDGE item on the IPDS Menu.
BUFFERSIZE	1024*	Specifies the IPDS buffer size in bytes. The SCS						buffer		size is
	256	always	256.
PORT TMEOUT	nnn	Specifies		the	number of	seconds the printer	waits	for	data before
		it determines there is no more data to receive						for	the	job. The
		printer then checks other installed attachments, and switches to
		attachments with jobs waiting. Valid values are 5 to 300. The
		default	is	90	seconds.

Chapter 5. Operator Panel Menus101