Chapter 4 - Configuring Impulse with Application Developer
4-16
X-Smoothness #2
Recommended values for M1 and M2 have been pre-configured for IDC motors, but we
recommend that these settings be verified and adjusted if necessary by the following procedure.
5. Press the Run Test button.
6. Move slider M1 to approximately 8,000.
7. Move slider M2 left and right until the smoothest running condition is reached.
8. Move slide M1 left and right until the smoothest running condition is reached.
9. Press Stop Test.
X-Smoothness #3
10. Press the Run Test button.
11. Move slider H1 left and right until the smoothest running condition is reached.
12. Move slider H2 left and right until the smoothest running condition is reached.
13. Press Stop Test.
14. Click OK.