Kodak 20P Electrical, Nominal Voltage/Frequency Voltage Range Power Consumption, Processor 208

Specifications

Electrical

The KODAK PROFESSIONAL LED II Printer 20P and the KODAK PROFESSIONAL LED II Processor are manufactured to operate within one of the following sets of power constraints or can be configured to do so by your Kodak representative:

Nominal Voltage/Frequency	Voltage Range	Power
		Consumption
Printer: 200 - 240V, 15A, 50/60	Printer: 190 - 254V, 47 -	Less than
Hz, 1 phase	63 Hz, 1phase, 15 A	9.12kVA
Processor: 230V, 30A, 50/60	(Automatic Sensing)
Hz, 1phase or 3 phase	Processor: 208 - 254V,
(selectable at installation)*	47 - 63 Hz, 1phase,
	30A**

*Phase selection must be completed at the factory or by a trained Kodak representative.

**Outside the U.S. and Canada, amperage for the printer is 16A, and the amperage for the processor is 32A.

NOTE: To prevent processor failures caused by power fluctuations, purchase a Square-D Buck and Boost Transformer (Model #500SV43F) EK Catalog #869-7799. Other transformers may not provide satisfactory results.

Consult with your electrical contractor or utility company to ensure that on-site wiring complies with the printer specifications and that wall outlets use isolated grounds and comply with codes. Further information is provided in the following sections.

If the equipment is to be permanently connected, then the equipment must be provided with its own circuit breaker that is located near the equipment within easy reach of the operator and marked as the disconnecting device for the equipment.

A protective earth ground must be supplied when installing the processor.

The unit is an Insulation Category Type II machine, and operates in a Pollution Degree 2 environment in accordance with IEC 664 (Normal Office Environment).

For technical support, service, repair and fuse replacement information, contact

Eastman Kodak Company’s Technical Assistance Center at 1-800-822-1414.

B-4 September 2000