Specifications
Power Cords
A 2.4 m (8 ft.), grounded power cord with a special three prong plug is provided with your printer. In addition, an 2.4 m (8 ft.), grounded power cord with a three prong plug is provided with your processor. The printer conforms to the NEMA N6/
15Printer Plug Specification. The processor conforms to the NEMA
Special plugs and cords may be required outside of the United States and Canada. These plugs and cords will be provided by the Kodak distributor (the power cord provided for international locations must have at least 14 gauge wire for the printer and 10 gauge wire for the processor).
The power cords should be certified and approved by a national test house.
For technical support, service, repair and fuse replacement information, contact Eastman Kodak Company’s Technical Assistance Center at
CAUTION: Make certain nothing obstructs or is placed on power cords. Do not use extension cords; they can cause voltage loss which may result in unreliable equipment performance or equipment damage.
Power Outlets
A separate, dedicated power line with a 208 V, 15 amp dedicated receptacle is required for the printer.
A separate, dedicated power line with a 208 V AC, 30 amp dedicated receptacle is required for the processor.
The outlets should meet the following standards.
| Printer | Processor |
|
|
|
|
|
|
amperage | 15 amp | 30 amp |
|
|
|
wire size | 14 gauge or larger | 10 gauge or larger |
|
|
|
phase | 1 (single) | 3 or 1 |
|
|
|
receptacle | NEMA5— N6/15 | NEMA6— 30R |
|
|
|
impedance between | less than 2 ohms | less than 2 ohms |
ground and neutral |
|
|
wires |
|
|
|
|
|
voltage drop across | less than 0.1 volts | less than 0.1 volts |
the circuit breaker |
|
|
|
|
|
distance between | 1.5 m (5.0 ft.) | 1.5 m (5.0 ft.) |
receptacle and | or less | or less |
equipment |
|
|
|
|
|
September 2000 |
