System Operating Procedures
Accessing the Printer Features
Shutdown and Restart
Shutdown
1.Select “Shutdown” from the main menu on the OCP.
2.Select “Shutdown NOW?”
This causes the printer to shut down operations and enter the standby mode.
Restart
1.Select “Restart” from the main menu on the OCP.
2.Select “Restart NOW?”
This causes the printer to immediately shutdown operations and reboot.
IMPORTANT: This shutdown is not a soft shutdown and does not save the parameter settings that have been made since the previous startup. Also, using this feature may cause a black line on the paper in the shoe.
Unload Supply
1.Select “Unload Supply” from the main menu.
2.Select “Unload Supply NOW?”
The printer enters its unload paper sequence. When the unload paper sequence is complete, the OCP returns to the main menu.
3.Select “Exit” to return to the OCP display. You are prompted to load another roll of paper into the printer.
Selecting SCSI Ports
1.Select “Setup” from the main menu on the OCP.
2.Select “Ports”.
3.Select “SCSI”.
4.Select “SCSI Target ID”.
5.Use the Up and Down Arrows to select a new SCSI ID. The allowable SCSI IDs are 0, 1, 2, 3, 4, 5, 6, 7.
6.Press Select to select/set the new value.
7.Select “Exit” to return to the previous menu on the OCP.
September 2000 |
