System Operating Procedures
Resetting the Defaults
Resetting the Parameters
This procedure resets the parameters of the printer to the factory setup (default) values. To indicate that the values have been reset to the factory setup values, the word “done” is displayed in parenthesis after “Reset Parameters To Factory” on the menu.
NOTE: Diagnostic parameters are not reset by this action.
1.Select “Setup” from the main menu on the OCP.
2.Select “Defaults”.
3.Select “Reset Parameters to Factory”.
4.Select “Exit” to return to the previous menu on the OCP.
Resetting the Printing LUTs
This procedure resets the Printing LUTs stored in nvram to the factory setup (default) values. To indicate that the values have been reset to the factory setup values, the word “done” is displayed in parenthesis after “Reset Printing LUTs To Factory” on the menu.
1.Select “Setup” from the main menu on the OCP.
2.Select “Defaults”.
3.Select “Reset Printing LUTs to Factory”.
4.Select “Exit” to return to the previous menu on the OCP.
Resetting the Copyright Detection LUTs
This procedure resets the Copyright Detection LUTs stored in nvram to the factory setup (default) values. To indicate that the values have been reset to the factory setup values, the word “done” is displayed in parenthesis after “Reset Copyright LUTs To Factory” on the menu.
1.Select “Setup” from the main menu on the OCP.
2.Select “Defaults”.
3.Select “Reset Copyright LUTs to Factory”.
4.Select “Exit” to return to the previous menu on the OCP.
September 2000 |
