Kodak 20P manual Loading the Defaults and Changing the Configuration

Viewing/Setting Replenishment Settings	3-36
Viewing the Replenishment Rate	3-36
Setting the Chemical Replenishment Rate	3-36
Setting the Wash Replenishment Rate	3-36
Calibrating the Replenishment Flow Rate	3-36
Measuring the Flow Rate	3-36
Entering the Flow Rate	3-37
Managing the Development Time	3-37
Viewing the Development Time	3-37
Setting the Development Time	3-37
Calibrating the Development Time	3-37
Displaying the Min Max Development Time	3-38
Managing the Material Sensors	3-38
Viewing the Material	3-38
Viewing the Processor Setup	3-38
Selecting the Processor Setup	3-38
Controlling the Processor Drive	3-39
Turning the Drive On	3-39
Returning the Drive to Normal Operation	3-39
Computer Reset	3-39
Resetting the Processor	3-39
Loading the Defaults and Changing the Configuration	3-39
Changing the Wash/Stabilizer Setup	3-40
Changing the Metric/Fahrenheit Mode	3-40
Setting the Development Time Tolerance	3-41
Setting the Chemical Temperature Tolerance	3-41
Clearing Error Conditions	3-41
4 Maintaining the Equipment	4-1
Maintaining the Printer	4-2
Daily Maintenance	4-2
Removing the Chad	4-2
Calibrating the Printer	4-2
Periodic Maintenance	4-3
Replacing the Air Filter	4-3
Maintaining the Processor	4-4
Daily Maintenance	4-4
Chemistry Levels	4-4
Replenishment and Effluent Chemical Levels	4-4
Cleaning the Crossover Assemblies	4-5
Operational Checks	4-6
Testing	4-6
Weekly Maintenance	4-7
Checking the Tension of the Main Drive Chain	4-7
Checking the Circulation	4-7
Preventing Algae (for Wash Configuration)	4-8
Cleaning the Crossover Assemblies and Transport Racks	4-8
Cleaning the Feed Table and the Processor Entrance Sensors	4-9
Replacing Chemical and Wash Filters	4-10
Checking the Fittings for Leaks	4-10

September 2000 ix