Lexmark MX511DHE, 35S5703, 35S5704 Understanding the printer menus 198, PCL Emulation Settings

Understanding the printer menus		198
	Use	To
	PCL Emulation Settings	Change the point size for scalable typographic fonts.
	Point Size	Notes:
	1.00–1008.00
		• 12 is the factory default setting.
		• Point size refers to the height of the characters in the font. One point
		equals approximately 0.014 of an inch. This can be increased or decreased
		in 0.25‑point increments.
	PCL Emulation Settings	Specify the font pitch for scalable monospaced fonts.
	Pitch	Notes:
	0.08–100.00
		• 10 is the factory default setting.
		• Pitch refers to the number of fixed‑space characters per inch (cpi). This
		can be increased or decreased in 0.01‑cpi increments.
		• For non‑scalable monospaced fonts, the pitch appears on the display but
		cannot be changed.
	PCL Emulation Settings	Specify the orientation of text and graphics on a page.
	Orientation	Notes:
	Portrait
		• Portrait is the factory default setting. It prints text and graphics parallel to
	Landscape
		the short edge of the page.
		• Landscape prints text and graphics parallel to the long edge of the page.
	PCL Emulation Settings	Specify the number of lines that print on each page.
	Lines per Page	Notes:
	1–255
		• 60 is the US factory default setting. 64 is the international default setting.
		• The printer sets the amount of space between each line based on the
		Lines per Page, Paper Size, and Orientation settings. Select the paper size
		and orientation before setting Lines per Page.
	PCL Emulation Settings	Set the printer to print on A4‑size paper.
	A4 Width	Notes:
	198 mm
		• 198 mm is the factory default setting.
	203 mm
		• The 203‑mm setting sets the width of the page to allow the printing of
		eighty 10‑pitch characters.
	PCL Emulation Settings	Specify whether the printer automatically performs a carriage return (CR) after
	Auto CR after LF	a line feed (LF) control command.
	On	Note: Off is the factory default setting.
	Off
	PCL Emulation Settings	Specify whether the printer automatically performs a line feed (LF) after a
	Auto LF after CR	carriage return (CR) control command.
	On	Note: Off is the factory default setting.
	Off