LG Electronics MF3800, MF2800 manual Connecting Class 1 to Your PC, Installing the PC-Fax Software

Class 1 Fax/Modem

Connecting Class 1 to Your PC

The MINOLTAFAX3800 uses a standard RS-232C port to communicate with the PC. Follow the instructions in “Attaching the Peripheral Cables” on page A-8 to connect the cable if you have not already connected it.

Please Note: CLASS 1 PC Faxing is optional..

Installing the PC-Fax Software

There are a number of settings that affect the modem. This table provides a list of common settings and the preferred MINOLTAFAX2800 and MINOLTAFAX3800 settings.

Modem type	Generic Class 1 or Class 1
Flow control	Xon/Xoff
Dial type	Use the type that matches your telephone service. This selection
	determines whether the dial command is ATDT for tone or
	ATDP for pulse.
Dial tone detect	OFF
Detect busy	OFF. Your unit detects a busy signal and provides the correct
	response. If the remote unit does not answer, the fax unit
	responds “No carrier” on the computer, which can then
	schedule a re-dial.

Speaker On/Off and volume

OFF

Using Class 1 Mode

Note these considerations when using Class 1 mode:

•When your unit communicates with the computer, “CLASS 1 MODE” appears on the LCD.

•No other fax activities can be performed while the MFD communicates with the PC.

•During a fax operation initiated by your unit, a fax request initiated by the PC is not processed.

•The maximum fax transmission speed is 14,400 bps in Class 1 mode.

6 - 19 PC Printing & Scanning