DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127 Issue 1
August 1997
Maintenance Object Repair Procedures
Page10-384DAT-LINE (Data Line)
10
Digital Loop Around Test (#171)
The Digital Loop Around Test checks the Data Line’s abi lity to transmit and
receive data on the TDM Bus. Data is sent through Network Control Data
Channel 3 (data channel port 3) over the TDM Bus, internally looped through the
Data Line back onto the TDM Bus, and received again by Network Control Data
Channel 3.
If data channel 3 is in use or not administered, this test aborts. This test may f ail if
Network Control Data Channel 3 is not functioning properly. If there are any
DATA-CHL errors in the Error Log, refer to the DATA-BD (Network Control Circuit
Pack) Maintenance documentation to clear them up first. This test passes
regardless of any customer equipment that may be connected to the port, as
long as the port is not in use by the equipment.
Table 10-124. TEST #36 Audit Update Test
Error
Code Test
Result Description/ Recommendation
1006 ABORT The test did not run due to an already existing er ror on this port (Error Type
769).
1. Refer to the procedure for Error Type 769. If Error Type 769 still occurs
on this port, replace the circuit pack.
2000 ABORT Response to the test request was not received within the allowable time
period.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
7 FAIL Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
PASS The har dware port state is consi stent wi th the so ftwar e state. User-r eported
troubles on this port should be investigated using other port tests,
examining the ADU, external wiring, and customer equipment.
Continued on next page