DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127 Issue 1
August 1997
Maintenance Object Repair Procedures

Page10-932PE-BCHL (PRI Endpoint Port)

10
PRI Endpoint Port Service States

The following table summarizes each of the different PRI End point Port service

states that can result when the status pri-endpoint <extension> command is

issued. From the results of the status command, match the service state to the

corresponding column. Proceed down the column until an "X" is found. The left

column indicates possible reasons why the port is in this state, and the right

column suggests possible recovery mechanisms. If an alarm against PE-BCHL is

present, it is indicated below the "X."

NOTE:

Refer to "Troubleshooting PRI Endpoint Problems" in Chapter 5, ‘‘Routine

Maintenance Procedures’’ for a layered approach to the processing of PRI

Endpoint problems.

Table 10-311. PRI Endpoint Port Service States
Possible
Problem
Source
O/S-NE
O/S-FE
O/S- FE Pend- ins
maint-NE
maint- FE
maint-FE Pend- ins
INS
Possible Recovery
Route
ISDN
wideband
calls being
completed.
X Normal Operation.
Port busied
out by
system
technician?
X
Warn
Alarm
Release port by the
release pri-endpoint
extension or release
port PCSSpp.
NPE
Crosstalk
Test failed?
X
Minor
Alarm
Replace UDS1
Interface CP.
DS1 circuit
pack lost
signal?
X UDS1 Interface CP
removed?
DS1 cable
disconnected?
Terminal adapter
problems?
Far-end terminal
adapter restarting?
Faulty UDS1
Interface CP?
Continued on next page