DEFINITY Enterprise Communications Server Release 6
Maintenance for R6vs/si
555-230-127 Issue 1
August 1997
Maintenance Object Repair Procedures

Page10-560DUPINT (Duplication Interface Circuit Pack)

10
Duplication Interface Circuit Pack Sanity Circuit Test (#273)
This test is destructive.

This test checks the sanity hardware of a Duplication Interface circuit pack. The

Duplication Interface circuit pack processor is instructed to allow the on-board

circuit pack sanity timer to expire, which should cause the circuit pack to reset

itself. The software then allows the Duplication Interface circuit pack 15 seconds

to reset. After this time, the Duplication Interface circuit pack is queried for the

results of its background tests (see Test #271). If the Duplication Interface circuit

Table 10-188. TEST #272 Duplication Interface Circuit Pack
Invalid Message Query Test
Error
Code Test
Result Description/Recommendation
1000 ABORT System resources required to run this test are not available.
2000 ABORT Response to the test request was not received within the allowable time
period.
2033 ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The Duplication Interface circuit pack is receiving an abnormal number of
corrupted messages.
1. First investigate other Duplication Interface circuit pack tests that are
not passing.
2. If this is the only test that fails, investigate and resolve all alarms
against PR-MAINT (Maintenance/Tape Processor).
3. Rerun the test. If the test still fails, follow the procedures for replacing
Common Control circuit packs and replace the Duplication Interface
circuit pack.
4. Rerun the test.
NO
BOARD The Duplication Interface circuit pack has failed to handshake with either
the active Maintenance/Tape Processor (in the case of Duplication
Interface circuit pack A) or the Duplication Interface circuit pack A (in the
case of Duplication Interface circuit pack B).
1. Refer to NO BOARD description for the Duplication Interface Circuit
Pack Status Query Test (#315).
PASS The Dupl ication Interface circuit pack has not received any bad messages
from either Maintenance/Tape Processor or the other Duplication Interf ace
circuit pack. All serial links are operating fine.
Continued on next page